Tips & Tricks assembly Netorious
How do I remove the Netorious packaging?
Caution: the tie wraps of the Netorious are very tight. We recommend using (small) wire cutters to carefully cut off the tie wraps so as not to damage the frame, even before use.
Check out the short video below:
The connector got stuck:
Place a screw in the slot and gently tap it to loosen the connector.
The screws do not fit:
First loosely put all 4 screws on each side to check if they fit. Then tighten them.
Another solution would be to replace the connectors connecting the two frame parts. The thread in the connector may be damaged or insufficient.
There are some loops of the net coming out of the frame:
The net may come out of the rail at certain points. This may be caused by incorrect mounting.
Make sure that the rope in the edge of the net is completely concealed in the rail of the frame. This may require some extra effort at the connection points of the frame.
Problems with the legs:
Make sure the front and back legs are on the right side of the frame, to make sure the frame position is correct. Look carefully at the drawings!
Problems with the straps:
The straps can be tightened to the point where you feel that there is tension in the net. Do not keep tightening them, the leg should not deform.
How do I mount the frame, with tension on the net?
There is tension on the net. To assemble the 2 parts of the frame of the Netorious, it is therefore best to hold them at an angle. Mounting the frame is a 2 person job! While both of you are holding the frame pieces at the same angle, you can align the connector and frame and flatten the Netorious simultaneously. Make sure this happens on both sides at the same time so the frame does not intersect at an angle. Make sure your fingers do not get stuck between the 2 frame parts!
How do I mount the net in the frame?
Before sliding the 2 frame parts tightly against each other, it is important that you guide the excess cord neatly into the rails. This takes a bit of effort. It helps to slide the net from left to right and keep tension it,
How does the ratchet work?
The ratchet consists of two parts that are joined together when delivered. Before assembling Netorious these parts must be detached first.. Watch the video to see how this works.